|
MSDS Name
|
Uni-Tack
Insulation Adhesive
|
|
Revision Date
|
February 1, 2010
|
|
|
Section 1: Chemical Product and Company Identification
|
|
Product Name
|
Uni-Tack
Insulation Adhesive
|
|
CAS Number
|
none
|
|
HMIS Hazard Rating
|
Health: 1, Fire: 1, Reactivity: 0
|
|
Company
Identification
|
McGill AirSeal LLC
2400 Fairwood Avenue
Columbus, Ohio 43207
|
|
Contact
|
McGill AirSeal LLC
|
|
Telephone
|
(800)624-5535, (614)829-1200
|
|
Fax
|
(614)829-1488
|
|
Chemtrec
(24-hour)
|
(800)424-9300
|
|
Chemtrec
International
|
(703)527-3887
|
|
Product
Class
|
polymer dispersed in water
|
|
Product
Use
|
adhesive
|
|
Product Code
|
6163, 6166, 6167, 6168
|
|
|
Section 2: Composition and Information about Ingredients
|
|
Hazardous Ingredients
|
CAS Number
|
Percent
|
|
Product contains no hazardous
ingredients or they are below reportable levels.
|
|
OSHA PELs and ACGIH
TL Vs are listed in Section 8 where applicable.
|
|
|
Section 3: Hazard Identification
|
|
Emergency
Overview
|
Material is a white
colored water based liquid that is slippery in the wet state.
|
|
Routes of Entry
|
Inhalation:
Yes; Ingestion: Yes; Skin: Yes; Eye: Yes
|
|
Inhalation
|
May be irritating to upper
respiratory tract.
|
|
Ingestion
|
Ingestion is not a probable route
of exposure. Harmful if swallowed.
|
|
Skin
|
Prolonged or repeated skin contact
can cause irritation.
|
|
Eye
|
Mildly irritating to eyes.
|
|
Medical Conditions
Aggravated by
Exposure
|
Under conditions of normal use,
chronic affects are not expected. Possible aggravation of pre-existing skin conditions.
|
|
Carcinogenicity
|
IARC:
No; NTP: No; OSHA: No
|
|
Reproductive Toxicity
|
This product has not been evaluated
for reproductive toxicity.
|
|
Target Organs
|
Eyes and skin
|
|
|
Section 4: First Aid Measures
|
|
Inhalation
|
Remove to fresh air. If difficulty persists
seek medical attention.
|
|
Ingestion
|
Call poison control center
immediately. Follow their specific instructions. Do not induce vomiting.
|
|
Skin
|
Wash with soap and water.
Contact a physician if irritation develops or persists.
|
|
Eye
|
Hold eyelids apart and flush
with plenty of water for at least 15 minutes. Seek medical attention.
|
|
|
Section 5: Fire-Fighting Measures
|
|
Flammability Class
(OSHA)
|
IIIB
|
|
Flash Point
|
>200°F; Setaflash
|
|
Explosive Range
|
Not applicable
|
|
Extinguishing Media
|
Use alcohol foam, carbon dioxide,
water spray, or ABC dry chemical when fighting fires involving this product.
|
|
Hazardous Combustion
Products
|
Oxides of carbon may be released
during combustion.
|
|
Fire-Fighting Procedures
|
Wear a NIOSH approved self-contained
breathing apparatus.
|
|
|
Section 6: Accidental Release Measures
|
|
Containment Techniques
|
Use inert absorbent to dike
the spill. Keep away from drains.
|
|
Clean-up
|
Spread absorbent over material
and scrape up material/absorbent and place in an approved container. If product has dried,
scrape up and place in an approved container.
|
|
Emergency Measures
|
Isolate hazard area. Keep
unnecessary and unprotected personnel from entering area. Wear all appropriate personal
protection equipment (PPE) (See Section 8).
|
|
|
Section 7: Handling and Storage
|
|
Handling
|
Wash thoroughly after handling.
Avoid prolonged or repeated contact with skin.
|
|
Storage
|
Keep from freezing.
|
|
Precautionary
Statement
|
KEEP OUT OF THE REACH OF CHILDREN.
|
|
|
Section 8: Exposure Controls and Personal Protection
|
|
Occupational Exposure Limits
|
|
ACGIH
TLV
|
Not
Applicable
|
|
|
ACGIH
TLV-C
|
Not
Applicable
|
|
|
ACGIH
STEL
|
Not
Applicable
|
|
|
OSHA
STEL
|
Not
Applicable
|
|
|
OSHA
PEL
|
Not
Applicable
|
|
|
Engineering Controls
|
Use local exhaust as needed to maintain
occupational exposure limits.
|
|
Other
|
Facilities storing or utilizing any
chemical should be equipped with an eyewash facility and a safety shower.
|
|
Respiratory
Protection
|
Respiratory protection is not
expected to be necessary under normal use. Follow requirements for respiratory protection
in OSHA 1910.134.
|
|
Eye Protection
|
Chemical splash goggles
(ANSI Z87.1 or approved equivalent).
|
|
Skin Protection
|
Where skin contact can occur,
wear impervious gloves.
|
|
|
Section 9: Physical and Chemical Properties
|
|
Form
|
liquid
|
|
Appearance/Color
|
white
|
|
Odor
|
faint odor
|
|
Solubility (in water)
|
miscible
|
|
pH Value
|
4.5
|
|
Boiling Range/Point
|
212°F
|
|
Evaporation Rate
|
slower than n-Butyl Acetate
|
|
% Volatile
|
63.6%
|
|
Specific Gravity
|
1.03
|
|
VOC
|
5.0 g/l
|
|
|
Section 10: Stability and Reactivity
|
|
Stability
|
This product is stable.
|
|
Hazardous
Polymerization
|
Hazardous polymerization
will not occur.
|
|
Conditions
to Avoid
|
Strong acids, strong bases
|
|
Incompatibility
|
Easily oxidizable materials
|
|
|
Section 11: Toxicological Information
|
|
This formulation
has a low odor of acute and chronic toxicity by all routes of exposure. Prolonged or repeated
exposure may cause skin irritation. Direct contact may cause eye irritation. Exposure to any
chemical substance, including those with a low order of toxicity, should be controlled and
minimized to avoid harmful effects.
|
|
|
Section 12: Ecological Information
|
|
This formulation has not been tested
for environmental effects.
|
|
|
Section 13: Disposal Considerations
|
|
Waste Disposal
|
Disposal of this product must
comply with all applicable federal, state, and local regulations.
|
|
Container Disposal
|
Disposal of this container
should comply with all applicable federal, state, and local regulations.
|
|
|
Section 14: Transport Information
|
|
|
UN Number: None
UN Pack Group: Not Applicable
UN Class: Nonhazardous
ICAO/IATA Class: Nonhazardous
IMDG Class: Nonhazardous
Shipping Name: Nonhazardous
|
|
Packaging may not be
approved for shipping by air. Contact McGill AirSeal for further information.
|
|
|
Section 15: Regulatory Information
|
|
TSCA (Toxic Substances Control Act Inventory)
|
|
All components of this product are
listed on the TSCA inventory except as exempted.
|
|
Pennsylvania
|
|
Non-hazardous components required to be listed at 3% or more
|
water; 7732-18-5
vinyl acrylic polymer emulsion; 29300-65-7
polyvinyl acetate emulsion; 24980-61-8
|
|
New Jersey
|
xanthan gum; 11138-66-2
biocide (mixture)
water; 7732-18-5
vinyl acrylic polymer emulsion; 29300-65-7
polyvinyl acetate emulsion; 24980-61-8
|
|
|
Section 16: Other Information
|
|
Disclaimer
|
While the information and
recommendations set forth herein are believed to be accurate as of the data hereof, McGill
AirSeal LLC makes no warranty, express or implied, with respect thereto and disclaims all
liability from reliance thereon.
|
|
©
Copyright 2001-2011 McGill AirSeal LLC
e-mail us: sales@mcgillairseal.com
An
enterprise of United McGill Corporation—Family owned and operated since 1951
All the trademarks (™) and registered trademarks (®) in this
Web site are the property of United McGill Corporation.
|